12V High-Pressure Self-Priming Diaphragm Water Pump 1000 PSI 4L/min – Black

12v water pump

Rated voltage：12V

Rated current：3A

Rated power：36W

Max head：70m

Water Flow GPM: 1

PSI: 1000

APMS : 7mpa

Maximum suction power: 1.6m

Hose Connector: 10mm

Initial self priming height：1.6m

Max flow rate：4L/min

Inlet and outlet diameter：10mm

Product size：134x76x62mm

Net weight：550g

Gross weight：720g

Attentions：

1.This pump sprayer has full-enclosing design and is rain-proof. However, it is not a submersible pump. Please do not put it in water.

2. Please remove the protective caps on the inlet and outlet, and correctly install the inlet and outlet pipes according to the arrows on the pump head.

3. The water pressure generated by this product is relatively high. Please fix the water pipe with a hose clamp to prevent water leakage.

4. It is strictly prohibited to use water pipes or wires to drag this product.

5. Sands or impurities can affect the operation of the diaphragm pump. Please use clean water and install the filter. After use, please do not drain the water inside the pump body. Please cover the water inlet and outlet with the protective caps. This will help extend the service life of the water pump.

Notice:

When the pump body is filled with air, the self-priming height generated by the

pump is limited. This product has a high suction head, which can reach 1.6m. If the pressure difference is greater than this and the liquid column cannot enter the pump body, the pump can be put to a lower position to reduce the pressure difference between the pump and the liquid surface. Once water enters the pump, the suction head increases to 10m.

Since there’s suction head in the inlet, please use pipes with enough rigidity for inlet. Too soft pipes may become flat because of the suction.